This site has been lacking a comment system for a long time (ever since its establishment in 2016). That was not a deliberate decision: I was simply too lazy to connect a proper comment system, and not much people wanted to leave a comment. I received almost no reach-outs due …
Read MoreIntro
This article is a part of the Edgeboard RISC-V series. Check out other articles as well if you came in through a search engine.
Besides setting up RISC-V bootloader, we need to have the PS side of Zynq set up properly for a proper system as well as ease …
Read MoreIntro
This article is a part of the Edgeboard RISC-V series. Check out other articles as well if you came in through a search engine.
Following the complete of setting up debug access, we can finally start the configuration for the first piece of software that will run on the …
Read MoreIntro
This article is a part of the Edgeboard RISC-V series. Check out other articles as well if you came in through a search engine.
After setting up the hardware system, we need a way to test if the system is actually running. The BootROM is the location where the …
Read MoreIntro
This article is a part of the Edgeboard RISC-V series. Check out other articles as well if you came in through a search engine.
After setting up the development environment and testing the board, we can finally start designing the RISC-V hardware system. This part of the series describes …
Read More